# Options you can adjust for all Raspberry Pi Revisions
# https://www.raspberrypi.com/documentation/computers/config_txt.html
# Raspberry Pi Zero 2W
[pi02]
kernel=rpi3-u-boot.bin
dtoverlay=upstream
# Raspberry Pi 3
[pi3]
kernel=rpi3-u-boot.bin
dtoverlay=upstream
# Raspberry Pi 4
[pi4]
kernel=rpi4-u-boot.bin
dtoverlay=upstream-pi4
# For RPi400 and newer rev RPi4s
arm_boost=1
# Enable DRM VC4 V3D driver
# dtoverlay=vc4-kms-v3d
dtoverlay=vc4-kms-v3d-pi4
dtoverlay=cma,cma-256
max_framebuffers=2
# 4K display support - RPi4 only, only one port possible
# hdmi_enable_4kp60=1
# Raspberry Pi CM4
[cm4]
otg_mode=1
# Default Fedora configs for all Raspberry Pi Revisions
[all]
# Put the RPi into 64 bit mode
arm_64bit=1
# Enable UART
# Only enable UART if you're going to use it as it has speed implications
# Serial console is ttyS0 on RPi3 and ttyAMA0 on all other variants
# u-boot will auto detect serial and pass corrent options to kernel if enabled
# Speed details: https://www.raspberrypi.org/forums/viewtopic.php?f=28&t=141195
# Terrible hack to work around U-Boot issues on most devices
enable_uart=1
# Early boot delay in the hope monitors are initialised enough to provide EDID
bootcode_delay=1
# We need this to be 32Mb to support VCHI services and drivers which use them
# but this isn't used by mainline VC4 driver so reduce to lowest supported value
# You need to set this to at least 80 for using the camera
gpu_mem=32
# Use eXtended firmware by default
start_x=1
# Automatically load overlays for detected cameras
camera_auto_detect=1
# Automatically load overlays for detected DSI displays
display_auto_detect=1
# Stop the RPi turning on HDMI monitors on reboot
hdmi_ignore_cec_init=1
# HAT and DT overlays. Documentation at Raspberry Pi here:
# https://www.raspberrypi.org/documentation/configuration/device-tree.md
# Each dtoverlay line is an individual HAT/overlay, multiple lines allowed
# dtoverlay=rpi-sense
# To use this on Fedora you need to use firmware provided device tree, not kernel
# For this functionality follow the following guide:
# https://fedoraproject.org/w/index.php?title=Architectures/ARM/Raspberry_Pi/HATs